Main Duties:
•
To carry out tank shell plate
handling, positioning and welding preparation activities under the direction of
a skilled Plater or Charge-hand.
•
To assist with the erection,
alignment and temporary support of tank shell courses, roof structure and floor
plates.
•
To prepare and clean weld joint
areas by grinding, wire brushing and chipping in readiness for inspection and
welding.
•
To handle, sort and stage
materials, components and consumables at the point of use.
•
To assist in the fitting-up of
nozzles, manholes, stiffener rings and appurtenances to tank shell and roof.
•
To operate a Telehandler (CPCS A17
Category C & E) for the safe lifting, placing and moving of materials and
equipment on the tank construction site.
•
To carry out weld treatment and
cleaning after completion of welded joints.
•
To provide standby / entry man and
firewatcher duties as required
•
To carry out general housekeeping
and waste segregation duties within the work area to maintain a safe and tidy
site.
•
To adhere to all applicable safety
requirements including pre-use checks of tools, plant and equipment; use of
correct PPE at all times.
•
To comply with the project Quality
Plan, Inspection & Test Plan (ITP) and any Hold/Witness points relevant to
semi-skilled activities.
•
To report defects, near-misses or
non-conformances to the Charge-hand or Site Supervisor immediately.
•
To use hand tools, power tools and
ancillary equipment associated with tank construction activities within the
limits of training and certification held.
Mandatory Qualifications
•
CPCS Red Card (Trained Operator)
or CPCS Blue Card (Competent Operator) — A17 Telehandler, Categories C (Lifting
& Placing) and E (Travelling with Load), both required.
•
Valid Site Safety Passport — CCNSG
Safety Passport or equivalent (e.g. CSCS, CISRS) accepted.
Desirable Qualifications & Experience
•
Previous semi-skilled experience
on above-ground storage tank construction or heavy industrial site fabrication.
•
Familiarity with tank construction
standards such as BS EN 14015 or API 650.
•
Basic grinding and surface
preparation competency.
•
Experience working within a
NAECI/CIJC labour framework environment.
•
Any relevant CITB or NVQ Level 2
qualification in a construction or engineering discipline.
•
Confined Space Entry – Medium Risk
Training